1/2" M NPT x 3/8" Tubing Fitting

John Guest 1/2" NPT x 3/8" Tube Push-Fit Adapter

A John Guest push-to-connect fitting with 1/2" male NPT threads on one end and a 3/8" tube push-fit on the other, no ferrules or compression nuts, the tube grips and seals itself once it's pushed in fully.

SPECIFICATIONS

• 1/2" male NPT x 3/8" push-fit tube connection

COMPATIBILITY

• Fits: any water line application using 1/2" NPT threads and 3/8" O.D. tubing

INSTALLATION

An easy DIY job, no tools needed for the tube side, just a wrench for the NPT threads.

PRO TIPS

• Cut the tube end square and deburr it before inserting, an angled or burred cut is the most common reason a push-fit connection weeps at the collet.
• Push the tube all the way to the internal stop, not just until it feels snug, a tube that's gripped but not fully seated can pull loose under pressure even though it looked secure going in.
• Keep this fitting away from cellulose paints, paint thinners, solder flux, and acid-based descalers or aggressive cleaners, they can attack the fitting's seals over time.