| Management number | 248408177 | Release Date | 2026/09/03 | List Price | US$3,876.00 | Model Number | 248408177 | ||
|---|---|---|---|---|---|---|---|---|---|
| Category | |||||||||
The Slayer 1-group is an all-around dream machine. Great for everyone from the serious consumer to the professional barista. It’s small enough to sit on a kitchen counter, light enough to carry to a pop-up cafe, and powerful enough to handle the highest demand.
Fully equipped with patented needle-valve technology for ultimate flow rate control, an independent brew tank for impeccable temperature stability, a commercial group head, and an individual tank for unlimited steam capacity. Steam and pull shots simultaneously and continuously without pressure drops or temperature loss. You’ll have all the necessary tools to extract the best flavors from each coffee over and over again. This machine was built for commercial use, but fits right in at home, too.
Water quality is very important on a Slayer Espresso Machine and you will void your warranty without it. So we recommend the following water filters for this machine; EV9613-21 or the 2015B with a Dual Head System.
| Warranty | 24-months |
| Electrical Configuration | 110V / 15A / 600W steam tank element |
| 220V / 10A / 2,000W steam tank element | |
| Brew Tank Capacity | 1.1 lt |
| Steam Tank Capacity | 3.3lt |
| Pre-heat Coil | 60.0 milliliters |
| Certifications | CE |
| Dimensions | |
| Body Length | 18.1 in (46.0cm) |
| Foot-Foot Length | 17.7 in (45.0cm) |
| Body Width | 24.3 in (61.7 |
| Foot-Foot Width | 17.5 in (44.4cm) |
| Width Total | 11.2 in (28.5cm) panel (top) to disengaged steam actuator (top) |
| Height | 12.8 in (323.8mm) top of rear panel |
| 13.4 in (340.3mm) top of brew actuator | |
| 14.5 in (368.3mm) top of engaged steam actuator | |
| 4.7 in (119.4mm) group height: drip tray to portafilter | |
| Weight | Dry: 100 lbs (45.5kg) |
| Wet: 110 lbs (49.9kg) | |
| Shipping: 160 lbs (72.60kg) |
If you notice any omissions or errors in the product information on this page, please use the correction request form below.
Correction Request Form